Fire Suit, Protective Clothing for fireman complete with gloves, boots helmets with suitable face shield made out of material capable of reflecting at least 950 C if radiant heat temperature around 150 to 2000 C and also afford same protection against direct flame. The suit will be sufficient size to accommodate the breathing apparatus to users.
Fire Entry Suit
Fire Proximity Suit Specification
• Fire Jacket
• According to EN469:2005 This garment is one part of the personal protective equipment stipulated by EN 469
• Fabric structure: 100 % Aramide lining laminated with watertight,
• Wind proof but breathable climate embrane made of polyurethane.
• On the inside, there is a permanently sewn-in
• lining made of Aramide non-woven with a quilted Aramide /viscose covering
• Colour: navy blue
• Design
• Length of jacket: 91 cm (length C)
• Wide shoulder seams give plentiful freedom of movement. Highly Heat resistant, stable zip with cover flaps.
• Two side hip pockets with flaps.
• Flame protection collar - on the backside to wear up to the helmet bottom, at the front closure with Velcro fastening.
• Nomex (r) knitwear wristlet.
• 5 cm wide silver strips at the ends of the jacket's back side and around The end of the sleeves.
• Sizes available: 44-46 to 60-64 in 3 lengths B (164-172), C (172-180) and D (180-188)
Fire Proximity Suit With Helmet
• Fire Fit Trousers
• According to EN469:2005
• This garment is one part of the personal protective equipment stipulated by EN 469
• Fabric structure: 100 % Aramide lining laminated with watertight,
• Windproof but breathable climate membrane made of polyurethane.
• On the inside, there is a permanently sewn-in lining made of Aramide non-woven with a quilted Aramide/viscose overing
• Colour: navy blue
• Design
• High kidney protection and elastic braces. 2 side hip pockets with flaps.
• Plentiful freedom of movement due to wide special low-cut step seam.
• Fly with zip and flap.
• On the trousers legs, 5 cm wide silver strips
• Sizes available: 44-46 to 60-64 in 3 lengths B (164-172), C (172-180) and D (180-188)
• HELMET as per EN 443
• The glass fiber reinforced helmet shell is yellow in colour. Complies with
• (EU Standard) and is approved as per EN 443. The interior harness is adjustable in size and exchangeable. The helmet allows for installation of impact sound microphones and accepts all types of BA masks.
• It is equipped with an integrated tilt-up visor made of highly heat resistant special
APEC-Carbonate, uncoated, housed within the helmet shell when not required for use.
• Adjustable safety type chin strap with "Velcro" fastening according to EN 443, for use in dangerous zones. Weight: approx. 1.3 kg. Comes complete with standard neck protection, made of flame resistant silver Polyurethane, lined with P 84, colour navy blue, fastened by "Velcro". Helmet without edge protection.